MV Agusta F4 S Workshop Manual page 338

Tighten the wheel pin fixing nut by rotating it clockwise
as shown in the figure, by using the following tools:
• Torque wrench
• 55 mm polygonal socket wrench
Slip flange nut coupling torque:
200-220 Nm
Apply grease only on the threaded part
Assemble the retaining ri ng (1).
Reassemble the lower chain pad, the upper chain
guard and the central exhaust manifolds respectively.
Rear wheel assembly
F
In the case of substitution of the rear tyre it
will be necessary to effectuate the balancing
of the wheel before assembling it. Follow the
instructions indicated in page 88.
Insert 1st gear. Reassemble the rear wheel.
Tighten the wheel axis nut to the prescribed torque
pressure.
Rear wheel RH nut torque pressure:
220 ÷ 240 N•m
Apply grease only on the threaded part
Insert the retaining ring (1).
Suspension and wheels
- 82 -
200÷220 N•m
220÷240 N•m
1
1