For Vigor2860Vac / Vigor2860Vn-Plus - Draytek Vigor2860 Series User Manual

1 . 2 . 3 F o r V i g o
1 . 2 . 3 F o r V i g o
LED
ACT (Activity)
WAN2
Line
USB
DSL
Phone1/Phone2
2.4G/5G
LED on Connector
WAN2
(Giga)
GigaLAN
1~6
Vigor2860 Series User's Guide
r 2 8 6 0 V a c / V i g o r
r 2 8 6 0 V a c / V i g o r
Status
Blinking
Off
On
Off
Blinking
On
Off
On
Blinking
On
Blinking
On
Off
Blinking
On
Blinking
Left On
LED
Off
Blinking
Right On
LED
Off
Left On
LED
Off
Blinking
Right On
LED
Off
2 8 6 0 V n - p l u s
2 8 6 0 V n - p l u s
Explanation
The router is powered on and running normally.
The router is powered off.
Internet connection is ready.
Internet connection is not ready.
The data is transmitting.
A PSTN phone call comes (in and out). However,
when the phone call is disconnected, the LED will be
off.
There is no PSTN phone call.
USB device is connected and ready for use.
The data is transmitting.
The router is ready to access Internet through DSL link.
Slowly: The DSL connection is ready.
Quickly: The connection is training.
The phone connected to this port is off-hook.
The phone connected to this port is on-hook.
A phone call comes.
Wireless access point with bandwidth of 2.4GHz/5GHz
is ready.
It will blink slowly while wireless traffic goes through.
ACT and WLAN LEDs blink quickly and
simultaneously when WPS is working, and will return
to normal condition after two minutes. (You need to
setup WPS within 2 minutes.)
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 1000Mbps.
The port is connected with 10/100Mbps
The port is connected.
The port is disconnected.
The data is transmitting.
The port is connected with 1000Mbps.
The port is connected with 10/100Mbps
8