Telnet Command: Msubnet Switch - Draytek Vigor2860 Series User Manual

-n <IP address>
-T <seconds>
-V
E x a m p l e
E x a m p l e
> mngt snmp -e 1 -g draytek -s DK -m 192.168.1.1 -t trapcom -n 10.20.3.40
-T 88
SNMP Agent Turn on!!!
Get Community set to draytek
Set Community set to DK
Manager Host IP set to 192.168.1.1
Trap Community set to trapcom
Notification Host IP set to 10.20.3.40
Trap Timeout set to 88 seconds
T e l n e t C o m m a n d
T e l n e t C o m m a n d
This command is used to configure multi-subnet.
msubnet switch [2/3/4/5/6][On/Off]
S y n t a x D e
S y n t a x D e
Parameter
2/3/4/5/6
On/Off
E x a m p l e
E x a m p l e
> msubnet switch 2 On
% LAN2
It means to set the IPv4 address of the host that will
receive the trap community.
It means to set the trap timeout <0~999>.
It means to list SNMP setting.
: m s u b n e t s w i t c
: m s u b n e t s w i t c
s c r i p t i o n
s c r i p t i o n
Description
It means LAN interface.
2=LAN2
3=LAN3
4=LAN4
5=LAN5
6=LAN6
On means turning on the subnet for the specified LAN
interface.
Off means turning off the subnet.
Subnet On!
h
h
645
Vigor2860 Series User's Guide