Table of Contents
Advertisement
VA
SLIDING DOOR (Continued)
(7) Loosen center roller bolt and adjust the front
and rear gaps.
(8) Check
rear
ridge
tighten bolt to 45 N·m (33 ft. lbs.).
Flush Adjustment
(1) Loosen upper roller arm screw. (Fig. 21)
(2) Loosen lower roller arm screws.
Fig. 21 IN/OUT ADJUST
1 - IN/OUT ADJUSTMENT SCREW - UPPER ARM
2 - IN/OUT ADJUSTMENT SCREWS - LOWER ARM
(3) Adjust front of door flushness by altering posi-
tion of top and bottom roller arms.
(4) Tighten upper and lower roller arm adjustment
screws.
(5) Install door striker and hand tighten the bolts.
(6) Adjust door striker in and out to adjust rear
door flushness.
(7) Tighten striker bolts to 25 N·m (18 ft. lbs.).
(Fig. 18)
(8) Loosen stabilizer closing wedge screws. (Fig.
22)
(9) Close sliding door to adjust closing wedge.
(10) Open door and tighten screws to 10 N·m (89
in. lbs.).
Door Stop Bumper Adjust
(1) Loosen door stop bumper bolts.
(2) Open sliding door and hold tight in end posi-
tion.
(3) Hold stop bumper tight against c-pillar and
tighten bolts to 10 N·m (89 in. lbs.).
pattern
alignment
and
Fig. 22 SLIDING DOOR STABILIZER
1 - SCREWS
2 - GUIDE WEDGES (2)
3 - SCREWS
4 - RECEIVERS (2)
STABILIZER
REMOVAL
(1) Remove screws and remove stabilizers. (Fig.
23)
Fig. 23 SLIDING DOOR STABILIZER
1 - SCREWS
2 - GUIDE WEDGES (2)
3 - SCREWS
4 - RECEIVERS (2)
INSTALLATION
(1) Install receiver and install screws.
(2) Tighten screws to 10 N·m (89 in. lbs.).
(3) Install wedge and install screws.
(4) Close sliding door to adjust closing wedge.
(5) Open door and tighten screws to 10 N·m (89 in.
lbs.).
DOORS - SLIDING 23 - 45
Advertisement
Table of Contents
