Table of Contents
Advertisement
VA
DOOR (Continued)
LEFT DOOR
(1) Remove door. (Refer to 23 - BODY/DOORS -
REAR/DOOR - REMOVAL)
(2) Remove trim panel (20) (Fig. 5). (Refer to 23 -
BODY/DOORS - REAR/TRIM PANEL - REMOVAL)
(3) Disconnect electrical connectors and remove
license plate lighting (18, 19).
(4) Pull out switch and disconnect electrical con-
nector (17).
(5) Remove and discard roll pin (12) and remove
lock rod handle (11).
(6) Remove door check (23). (Refer to 23 - BODY/
DOORS - REAR/CHECK - REMOVAL)
1 - UPPER LOCK ROD GUIDE
2 - UPPER LOCK ROD
3 - LEFT REAR DOOR
4 - TOP CLOSING WEDGE
5 - BOLTS (2)
6 - HINGE
7 - BOLTS (2)
8 - REAR DOOR SEAL
9 - SCREWS (2)
10 - LOCK ROD ACTUATOR
11 - LOCK ROD HANDLE
12 - ROLL PIN
13 - BOTTOM LOCK ROD
14 - SCREWS (2)
(7) Remove door hinge (6). (Refer to 23 - BODY/
DOORS - REAR/HINGE - REMOVAL)
(8) Remove closing wedge (4).
(9) Remove rivets (22) and remove bottom closing
wedge (21).
(10) Remove rear door seal (8).
(11) Remove the four screws (9, 14) from the lock
rod actuator.
(12) Using locking pliers, hold upper lock rod (2)
and remove lock rod actuator.
(13) Remove clips (15).
(14) Pull out lock rod guides (1, 16) and remove
lock rods (2, 13).
Fig. 5 LEFT DOOR
15 - CLIPS (2)
16 - BOTTOM LOCK ROD GUIDE
17 - SWITCHES
18 - ELECTRICAL CONNECTOR
19 - LICENSE PLATE LIGHTING
20 - TRIM PANEL
21 - BOTTOM CLOSING WEDGE
22 - RIVETS (2)
23 - DOOR CHECK
24 - BOLTS (2)
25 - FELT STRIP
26 - O-RINGS (2)
27 - THREADED PLATE
DOORS - REAR 23 - 27
Advertisement
Table of Contents
