Mercedes-Benz 2005 Sprinter Service Manual page 1081

VA
SLIDING DOOR (Continued)
ASSEMBLY
(1) Install the crash reinforcement (29). (Fig. 17)
(2) Install the bolts (28) and tighten to 21 N·m (15
ft. lbs.).
(3) Install upper roller arm (2). (Refer to 23 -
BODY/DOORS - SLIDING/UPPER
INSTALLATION)
(4) Install stabilizer wedges (6). (Refer to 23 -
BODY/DOORS - SLIDING/STABILIZER - INSTAL-
LATION)
(5) Install center roller arm (20). (Refer to 23 -
BODY/DOORS - SLIDING/LOWER ROLLER ARM -
INSTALLATION)
(6) Install exterior handle (10). (Refer to 23 -
BODY/DOORS - SLIDING/EXTERIOR HANDLE -
INSTALLATION)
1 - SLIDING DOOR
2 - UPPER ROLLER ARM
3 - BOLTS (2)
4 - TRIM PLUG
5 - BOLTS (2)
6 - STABILIZER PIN
7 - INSIDE HANDLE ACTUATOR
8 - SCREWS
9 - TRIM PLUG
10 - EXTERIOR HANDLE
11 - TRIM PLUG
12 - BOLT (1)
13 - NUT
14 - LATCH/LOCK CONTROL
15 - BOLT
(7) Install the latch/lock control (14). (Refer to 23 -
BODY/DOORS - SLIDING/LATCH / LOCK CON-
TROL - INSTALLATION)
(8) Install the rear latch (22). (Refer to 23 - BODY/
DOORS - SLIDING/REAR LATCH - INSTALLATION)
(9) Install lock rod (25) and connect to latch/lock
ROLLER -
control.
(10) Install the lock knob (27).
(11) Install the trim panel (24). (Refer to 23 -
BODY/DOORS - SLIDING/TRIM PANEL - INSTAL-
LATION)
(12) Install inside handle actuator (7). (Refer to 23
-
ACTUATOR - INSTALLATION)
(13) Install the center roller arm cover (23).
(14) Install the door. (Refer to 23 - BODY/DOORS
- SLIDING/SLIDING DOOR - INSTALLATION)
Fig. 17 SLIDING DOOR ASSEMBLY
16 - BOLT
17 - RELEASE CABLE
18 - WASHER
19 - BOLT
20 - CENTER ROLLER ARM
21 - RUBBER COVER
22 - REAR LATCH
23 - COVER
24 - TRIM PANEL
25 - CONNECTOR ROD
26 - GROMMET
27 - LOCK KNOB
28 - SCREWS
29 - CRASH REINFORCEMENT
DOORS - SLIDING 23 - 43
BODY/DOORS - SLIDING/INSIDE HANDLE