Table of Contents
Advertisement
VA
DOOR (Continued)
LEFT DOOR
(1) Install lock rods (2, 13) and install lock rod
guides (1, 16). (Fig. 7)
(2) Using locking pliers, hold upper lock rod (2) in
place.
(3) Install clips (15).
(4) Install the lock rod actuator (10). The bolts
should reach into the holes (arrows) of the lock rods
(2, 13). Place and o-ring (dia. 6 mm) on each of the
lock rod actuator bolts to prevent the lock rods from
chattering against the lock.
(5) Install rear door seal.
(6) Install bottom closing wedge (21) and replace
rivets (22).
(7) Install closing wedge (4).
(8) Install door hinge (6). (Refer to 23 - BODY/
DOORS - REAR/HINGE - INSTALLATION)
1 - UPPER LOCK ROD GUIDE
2 - UPPER LOCK ROD
3 - LEFT REAR DOOR
4 - TOP CLOSING WEDGE
5 - BOLTS (2)
6 - HINGE
7 - BOLTS (2)
8 - REAR DOOR SEAL
9 - SCREWS (2)
10 - LOCK ROD ACTUATOR
11 - LOCK ROD HANDLE
12 - ROLL PIN
13 - BOTTOM LOCK ROD
14 - SCREWS (2)
(9) Install door check (23). (Refer to 23 - BODY/
DOORS - REAR/CHECK - INSTALLATION)
(10) Install lock rod handle (11) and replace roll
pin (12).
(11) Connect the electrical connector and install
switches (17).
(12) Connect
license plate lighting (18, 19).
(13) Install trim panel (20). (Refer to 23 - BODY/
DOORS - REAR/TRIM PANEL - INSTALLATION)
(14) Install door. (Refer to 23 - BODY/DOORS -
REAR/DOOR - INSTALLATION)
Fig. 7 LEFT DOOR
15 - CLIPS (2)
16 - BOTTOM LOCK ROD GUIDE
17 - SWITCHES
18 - ELECTRICAL CONNECTOR
19 - LICENSE PLATE LIGHTING
20 - TRIM PANEL
21 - BOTTOM CLOSING WEDGE
22 - RIVETS (2)
23 - DOOR CHECK
24 - BOLTS (2)
25 - FELT STRIP
26 - O-RINGS (2)
27 - THREADED PLATE
DOORS - REAR 23 - 29
electrical
connectors
and
install
Advertisement
Table of Contents
