Suzuki GS850G Service Manual page 309

BALANCING FOUR CARBURETORS
Set each throttle valve in such a way that its
top end
( ( 1
meets
the foremost bypass
@
.
This
i s accomplished by turning throttle valve stop
wrew and balance screw.
Fuel level
gauge
FUEL LEVEL MEASUR'EMENT
09913-
1451 1
Distance
@ I
:
To check the fuel Iwel, proceed as follows:
Checking fuel level
in each
float
chamber
1. Leave fuel cock lever in "ON"
or
"RES"
position.
4.5
- 5.5
mrn
(0,18 - 0.22 in)
2. Place machine on center stand.
3.
Remove float chamber
s c r e w
and install
the special tool.
4. Move fuel
cock
lever to ' T R I " position to
When checking the fuel Iwel, place the
machine an the
center
stand. The fuel
admit fuel into float chamber.
5.
With the float chamber filled
with
fuel, turn
the cock lever back to "ON" position, and
start up the engine.
Fuel level adjustment
6. Run the engine
a t
the idling speed
(950
-
If dislance
'A1
is not within thespecified range,
1 150 r/min), and measure
distance
with
it means that float height is off the specification,
the middle line of the level gauge aligned with
to
adjust
this height, as shown
page
14-35.
the mating surface of the float bowl as shown
in
the illustration TAl should be within the
range specified here.