Suzuki GS850G Service Manual page 169

0
SIGNAL GENERATOR
Measure the resistance between lead wires. If the
resistance is infinity
or
less
than the
specifications,
the signal
generator must
be
replaced.
Pocket
tester
STD resistance
Approx. 1
40 -
1 80
S2
@
IGNITOR "NIT
Remove the spark plugs from Nos, 1 and 2 cyl-
inders. Install the respective plug
caps and place
spark plug on
the cylinder head.
w Remove the frame cover on the left side and dis-
connect the coupler from the signal
generator.
As indicated in Fig. 1, connect
the pocket
tester
alternately to the terminals provided inside the
coupler. For this test, use the "RXI" range of
the tester and set the ignition switch at the ON
position. If the ignitor unit is functioning
normally, a spark will occur a t rhe
spark plug a t
@
the
moment when both of the
fester pins @ and
@
are removed from the terminals sirnultane-
owsly.
09900 - 25002
Fig. 7
Aoc ket tester
I
I
NOTE:
This checking presupposes that the
ignition
coil used for checking is a good one.