Suzuki GS850G Service Manual page 113

Use the
"C"
rings and bearing stopper pins
to position the bearings
as
shown in the
photo.
Insert gear shifting cam into the lower
crankcase. Confirm the neutral position of
gear shifting cam, mount cam stopper,
spring and cam stopper holder
and
fasten
the cam stopper holder.
Insert gear shifting fork shaft from the right
side and mount gear shifting fork and cam
stopper
as
shown in the photo.
A t
this time, pay attention to the direction
of the gear shifting fork.
O
Gear shifting fork for 3rd drive gear.
C? Gear shifting forks for 4th and 5th driven
gears.
9 Cam stopper.
Apply engine oil to gear shifting fork and
gear shifting cam,
Completely wipe off oil on the mating
surface
of lower crankcase
and
apply
sealing compound
(SUZUKI BOND NO.
1207B; 991 04-3
1 1401 uniformly
to
the
mating surface.
D o
not forget "0" ring Q
.
*
Place the lower crankcase on the upper
crankcase housing the transmission gears
and crankshaft. Align shift forks into gears.
Fasten together the upper and lower
crankcase halves using the crankcase
fastening bolts.
The
lower crankcase fastening bolts must be
tightened securely in the order of the numbers
embossed on the crankcase.
6 m m bolt.
. . . . . . . . . . . . . . . . . . .
11
pcs.
8 mrn bolt.
. . . . . . . . . . . . . . . . . . .
13 pcs.
Tightening torque tor
8-mm hnlts
1.0 kg-m
7-60