Installing The Driver While Installing Freebsd On The 3Ware Raid Controller - AMCC 3ware Installation Manual

Installing the Driver While Installing FreeBSD on the 3ware RAID Controller

drive. If you do not insert it immediately, the loader may fail to
recognize the floppy drive.
7 At the loader prompt, run 'lsdev' to make sure the floppy drive
has been discovered.
8 Run 'load disk0:twa.ko' (assuming disk0 is the floppy drive)
9 Run 'boot'.
The system should now be able to boot.
10 After the system boots up, change the kernel build
infrastructure to include the 3ware driver sources.
a Change to the following directory:
cd /usr/src/sys/i386/conf
opy the configuration file to a custom file. For exam-
b C
ple, if the configuration file is GENERIC, type
cp GENERIC custom
c Edit the custom file and add the lines shown below under
RAID controllers
device twa # 3ware Escalade 9000 series
d Save the file.
e Change to the following directory:
cd /sys/conf
f Edit the file "files.i386" and add the lines shown below
dev/twa/twa.c
dev/twa/twa_cam.c
dev/twa/twa_freebsd.c
dev/twa/twa_fwimg.c
dev/twa/twa_globals.c
g Save the file.
h If you intend to bundle the firmware image with the driver,
add the following line to /sys/conf/options:
TWA_FIRMWARE_FLASH
www.3ware.com
optional twa
optional twa
optional twa
optional twa
optional twa
opt_twa.h
91