Table of Contents
Advertisement
The unit is not actually created and no data is overwritten until
you have finished making all your changes and press F8.
2
If you have additional drives, go ahead and configure an
additional RAID unit or designate a hot spare.Then continue on
with the next section. (For details about hot spares, see
page 46.)
3
If you configured more than one unit, and you plan to install the
operating system on one of them, make that unit be the first unit
(Unit 0) in the list of Exportable Units.
To move a unit up in the list, highlight it and press the Page Up
key.
4
When you are finished configuring units, press F8 to save the
changes and exit 3BM.
A warning message asks you to confirm that all existing data on
the drives will be deleted.
Figure 13. Confirmation Message when Saving and Exiting
www.3ware.com
Specifying the Unit Configuration
45
Advertisement
Table of Contents
