Table of Contents
Advertisement
Migrating Units from an 8000 Controller to a 9000 Controller
4
Reboot the system and enter the 3ware 9000 series BIOS
(3BM) by pressing Alt-3. Enable the Export JBOD policy on
the Policy screen. (The next section in this guide, "Configuring
Units", describes how to work in 3BM. Additional information
about 3BM is available in 3ware 9000 Series Serial ATA RAID
Controller User Guide.)
5
Press the F8 or Esc key to save and exit.
To migrate legacy JBOD units under Windows
1
Install the 9000 controller in your system, while leaving the
8000 controller installed.
2
Install the Windows driver. (For details, see "Driver Installation
Under Windows" on page 53.)
3
Power down the system, disconnect the drives from the 8000
controller and remove that controller from the system.
4
Attach the drives to the 9000 board.
5
Reboot the system and enter the 3ware 9000 series BIOS
(3BM) by pressing Alt-3. Enable the Export JBOD policy on
the Policy screen. (The next section in this guide, "Configuring
Units", describes how to work in 3BM. Additional information
about 3BM is available in 3ware 9000 Series Serial ATA RAID
Controller User Guide.)
6
Press the F8 or Esc key to save and exit.
www.3ware.com
25
Advertisement
Table of Contents
