Determining The Current Version Of Your 3Ware Driver; Driver Installation Under Red Hat Linux; Materials Required - AMCC 3ware Installation Manual

Sata raid controller
Hide thumbs Also See for 3ware:
Table of Contents

Advertisement

refer only to the 9000 series driver. For information about using the
7/8000 driver and controller, refer to the user guide or installation
procedure for the 7/8000-series controller.
Warning:
processor.
3ware offers both Intel x86 and AMD Athlon 32bit
drivers. Be sure you load the correct driver on your
system. It is possible to load the Intel x86 driver onto an
AMD Athlon system, however when you boot, it will not
work.
Determining the Current Version of
your 3ware Driver
If you already have a 3ware controller installed and want to check
your current 3ware driver version number, type the following
command:
cat /proc/scsi/3w-9xxx/*
where the asterisk (*) represents SCSI host ID and "9xxx"
represents the family of the controller. For example:
cat /proc/scsi/3w-9xxx/0
Driver Installation Under Red Hat
Linux

Materials Required

3ware software CD-ROM
Floppy diskette, if you need to create a driver diskette.
Red Hat Linux installation CD-ROM and boot disk. (Not
required if Red Hat Linux is already installed on another drive.)
www.3ware.com

Determining the Current Version of your 3ware Driver

Be sure to use the correct driver for your
67

Advertisement

Table of Contents
loading

Table of Contents