Symbol MK2000 MicroKiosk Product Reference Manual page 98

MK2000 MicroKiosk Product Reference Guide
Remapping Buttons
The four buttons can be used individually, or in combinations. 14 of the 15 combinations
can be remapped to a virtual keycode that represents a given character or key sequence,
as defined in the table at the end of this section. The other combination is permanently
mapped to reset. Use the Control Panel - Button Definitions utility to remap the buttons.
Button Combo
A
B
C
D
AB
AC
AD
ABC
ABD
ACD
BC
BCD
BD
CD
ABCD
Note 1: To disable a button combination, set its mapping to 0.
Note 2: To perform a cold boot press and hold buttons B and C until the display goes blank
(typically 15 seconds) then release buttons, see Figure 1-1 on page 1-3. The MK2000
reboots.
6-4
Table 6-2. Remapping Buttons
Mapping (Default or Permanent)
Up (D)
Down (D)
Left (D)
Right (D)
Enter/Return (D)
Alt-Down (pop-up combo box list) (D)
Alt (D)
(see Note 2 below)
Shift-Tab (move to previous control) (D)
Calibration (D)
Reset (P) (see Note 2 below)
(see Note 2 below)
Tab (D)
Cancel/Escape (D)
(see Note 3 below)
Hex Code
0x26
0x28
0x25
0x27
0x0D
0xC3
0x12
0xC2
0xC4
0x09
0x1B