Starting The Resident Demo Application - Symbol MK2000 MicroKiosk Product Reference Manual

MK2000 MicroKiosk Product Reference Guide

Starting The Resident Demo Application

Prior to launching the Resident Demo Application print out the Demo Application Bar Codes
on page C-1. The printed bar codes are required to access the MK2000 features. The
Resident Demo Application can be set to launch automatically on MK2000 boot up.
Automatic Resident Demo Application Launch
Apply power to the MK2000 and allow the boot sequence to proceed uninterrupted and
the Resident Demo Application will automatically launch.
Exit the Resident Demo Application and Launch the Windows
1. To perform a cold boot press and hold buttons B and C until the display goes blank
(typically 15 seconds) then release buttons, see Figure 1-1 on page 1-3. The
MK2000 reboots.
2. To prevent the MK2000 from entering an application, simultaneously hold down
buttons A and D just after the blue Performing System Initialization (Phase 1)
screen appears. The A and D buttons must be held down before the message
changes to Phase 2.
3. When the Enter Password prompt appears, enter DDBAC and touch OK on the
screen, or simultaneously press the A and B buttons for Enter.
4. The MK2000 enters Protected Mode and the Win CE desktop appears.
4-6
®
CE Desktop