Network Management; Dhcp (Dynamic Host Configuration Protocol) Server - Panasonic KX-TDA50 Manual

1.2 Network Management

1.2 Network Management
1.2.1

DHCP (Dynamic Host Configuration Protocol) Server

For IP-PTs to communicate over a network, an IP address must be assigned to each IP-PT to identify its
locations on the network. While these addresses can be assigned manually at each IP-PT, it is also possible
to use a DHCP server.
A DHCP server automatically assigns IP addresses to IP-PTs when they are connected to the network. An
IP-PT then uses the received IP address information to register to the IP-EXT card.
Using a DHCP server allows you to centrally manage and automate the assignment of IP addresses.
When an IP-PT is connected
to the network
1 Request IP address
2 IP address information
DHCP Server
assigned to IP-PT
IP Address: 192.168.0.101
Subnet Mask Address: 255.255.255.0
Default Gateway Address: 192.168.0.1
Notes
• The Hybrid IP-PBX is not able to act as a DHCP server. To use the DHCP client function of IP-PTs,
a separate DHCP server is required on the network, as shown above.
• The IP address for the IP-EXT card cannot be assigned automatically using a DHCP server. This
IP address must be assigned manually by using the Maintenance Console (PC programming
software of the Hybrid IP-PBX). For details, refer to "4.1 Programming the IP-EXT Card".
• An IP-PT cannot request an IP address from a DHCP server on another LAN (connected through
an IP network). An IP-PT can only receive IP address information from a DHCP server on its own
LAN. Therefore, when IP-PTs are located on several LANs, a DHCP server is required on each
LAN. If a DHCP server is not present on the LAN, IP addresses for IP-PTs on that LAN must be
assigned manually.
8 Information about IP Proprietary Telephones
When the IP-PT is registered
to the IP-EXT card
Request registration using the
3
received IP address information
4 Establish connection
IP-PT
IP-EXT Card