Panasonic KX-TDA50 Manual page 36

4.2 Programming the IP Proprietary Telephone
When Assigning IP Addresses to IP-PTs Without Using a DHCP Server
If you are not using a DHCP server on the network, you will have to set an IP address and subnet mask
address to the IP-PT, in addition to the PBX IP address. If necessary, also enter the IP address of the default
gateway.
Follow the procedure below for all IP-PTs on the network, using appropriate IP addressing information.
If you need to set VLAN parameters, follow the procedure described in "4.2.2 Setting the VLAN Parameters"
after assigning the IP addresses without ending programming.
IP-PTs with a multiline display (e.g., KX-NT136)
To start programming
Supply power to the IP-PT.
To set the IP address of the IP-PT
Select "Network". ENTER
To set the subnet mask address
Select "Subnet Mask".
To set the default gateway address (if required)
Select "Default Gateway".
To enter the IP address of the IP-EXT card (PBX IP Address)
Return to the
Menu screen.
To set VLAN parameters
To the VLAN settings
OR
To end programming
STORE
Press "STORE".
*1 Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2 Valid IP address range: "0.0.0.0" to "255.255.255.255"
*3 Valid IP address range: "1.0.0.0" to "223.255.255.255"
36 Information about IP Proprietary Telephones
SETUP
Press "SETUP" when it is displayed.
Select "Disable" Select "IP Address".
for DHCP setting.
Subnet Mask Address*
ENTER
Default Gateway Address*
ENTER
Select "PBX". ENTER
The IP-PT will reboot
and establish connection
to the network.
IP Address*
ENTER
2
ENTER
3
ENTER
1
PBX IP Address*
1
ENTER
ENTER