Bosch Dinion IP NWC-0495 Installation Manual page 84

Dinion IP
| Installation Manual
site. The latest firmware can be obtained from your customer service center or
from the Bosch Security Systems download area.
Caution
Before starting the firmware update, make sure that you have selected the
correct upload file! Uploading the wrong files can result in the unit no
longer being addressable, requiring it to be replaced.
Caution
Do not interrupt the firmware installation for any reason! Interruption may
lead to faulty coding of the Flash EPROM. This can result in the unit no
longer being addressable, requiring it to be replaced.
Note
A firmware update resets all camera parameters to their factory default
values. If you wish to retain the old values first save the configuration by
performing a configuration download. After the firmware update you can
reload your parameter values by performing a configuration upload.
To update the firmware:
– First, save the update file to the hard disk.
– Enter the full path for the update file in the field or click Browse... to locate
and select the file.
– Click Upload to begin transmission to the unit. The progress bar allows you to
monitor the transfer.
Note
Installing new firmware and reconfiguring the camera takes several
minutes.
The new firmware is unpacked and the Flash EPROM is reprogrammed. The
time remaining is shown by the message going to reset Reconnecting in ...
seconds. After the upload is completed successfully, the unit will restart
automatically.
If the operating status LED lights up red, the upload has failed and must be
repeated. To perform the upload, you must switch to a special page:
Bosch Security Systems | 2006-05 | V2.0
EN | 83