Alarm Settings; Alarm In; Alarm Connections - Bosch Dinion IP NWC-0495 Installation Manual

Dinion IP
| Installation Manual EN | 67

Alarm Settings

Here, you can make the settings for the alarm sources and alarm connections.

Alarm in

You can configure the possible alarm triggers for the camera.
Alarm input 1
Select the option On in order to activate the alarm via the corresponding
external alarm sensor. Otherwise, select Off.
Select Active Low if the alarm is to be triggered by closing the contact. Select
Active High if the alarm is to be triggered by opening the contact.
Name
You can enter a name for each alarm input, which is then displayed below the
icon for the alarm input on the Livepage during configuration.

Alarm connections

You can select the response of the camera in case of an alarm. In case of an alarm,
the camera can automatically establish a connection to a predefined IP address
(compatible MPEG-4 compatible hardware receiver or computer with reception
software). You can enter up to ten IP addresses which will be selected in order by
the unit in case of an alarm until a connection is established.
Bosch Security Systems | 2006-05 | V2.0