Throughput Too Slow For Wlan N; Cannot Access Devices In The Network - Fritz! WLAN Repeater Installation And Operation Manual

Throughput Too Slow for WLAN N

6.5 Throughput Too Slow for WLAN N
A WLAN device (for instance, a computer) connected with the
FRITZ!WLAN Repeater should use the 802.11n (WLAN N)
standard for high data transmission speeds. The throughput
achieved by this device is too low for WLAN N.
Cause
In the FRITZ!WLAN Repeater, in the WLAN base station, or in
both devices, an encryption method other than WPA2 has
been configured.
Help
The 802.11n WLAN standard can be used only with the en-
cryption method WPA2. Set the WLAN base station and the
FRITZ!WLAN Repeater to WPA2.
You can also use the 802.11n WLAN standard in non-encrypt-
ed (open) WLAN networks. However, an open WLAN radio
network is a security risk. Therefore we strongly recommend
encrypting all WLAN radio networks!
6.6

Cannot Access Devices in the Network

No other devices in the network can be accessed.
Cause
A firewall is running on the devices.
Help
Configure the firewall to allow access to the network.
Cause
The devices are not configured to receive their IP addresses
automatically.
Help
Set up the devices as directed in the section
Address Automatically
FRITZ!WLAN Repeater 310
from page 27.
26
Obtaining an IP