Setting The Operating Program For Central Heating; Setting The Time Program For Central Heating - Viessmann VITOTROL 300 RF Operating Instructions Manual

Central heating

Setting the operating program for central heating

Factory setting (Vitotronic control unit):
"Heating and DHW"
Standard menu
1. "Heating circuit 1", "Heating circuit
2" or "Heating circuit 3".
2. If is displayed, no other changes
are necessary.
If or is displayed, press that sym-
bol.
Wednesday 25.05.2011 13:42
14°
Heating circuit 1

Setting the time program for central heating

Factory setting (Vitotronic control unit): A
time phase is set for every day of the
week from 06:00 to 22:00 h for rooms to
be heated to 20 °C (room temperature
for standard heating mode).
20
20.5°
Menu
3. "Heating and DHW".
Operating program
Heating and DHW
Only DHW
Standby mode
Heating circuit 1
4. "OK" to confirm.
■ The rooms of the selected heating cir-
cuit are heated in accordance with the
room temperature and time program
settings.
■ DHW is reheated in accordance with
the set DHW temperature and time
program.
■ The time program for central heating is
made up of 1 to 4 time phases.
In the Extended menu, you can scan
the current time program under "Infor-
mation" (see page 35).
■ The time program can be set individ-
ually.
You can select up to 4 time phases per
day for standard heating mode. Set the
"Start" and "End" points for each time
phase. Between these time phases,
the rooms are heated to the reduced
room temperature (see page 19).
■ When adjusting the setting, bear in
mind that your heating system
requires some time to heat the rooms
to the required temperature.
ç
OK