Creating An Original Effect - Yamaha cvp-701 clavinova Reference Manual

3
Use the [3]/[4] buttons to select the part to which you want to apply the effect.
Note that a part cannot be selected if "REVERB" or "CHORUS" is selected, or if the CONNECTION
parameter of "DSP1" is set to "System" (in step 3 of "Creating an Original Effect" below). This is because
only one of the Effect Types can be selected to be commonly applied to all available Parts.
4
Use the [5]/[6] buttons to select the effect CATEGORY.
5
Use the [7]/[8] buttons to select the effect TYPE.
If you want to edit the effect parameters, go on to the next operation.

Creating an Original Effect

1
Once you've selected an Effect Block and Effect Type above, press the [F] button to
call up the display for editing the effect parameters.
2
Select the desired parameter for editing by using the [2] – [4] buttons, then
adjust the value by using the [5]/[6] buttons.
If you have selected the REVERB, CHORUS or DSP1 effect block, you can adjust the Effect Return Level
by pressing [7] button.
Keep in mind that in some cases noise may result if you adjust the effect parameters while playing the instrument.
3
If DSP 2 – 4 is selected as the Effect Block, edit the Variation parameter if desired.
Press the [7] (VARI. DETAIL) button to call up the Variation parameter, select a parameter via the
[2] – [4] buttons, and then use the [5]/[6] buttons to edit the value. This parameter is
effective only when the DSP VARIATION in the VOICE EFFECT display is set to on. To close the
Variation parameter display, press the [EXIT] button.
2
4
CVP-701 Reference Manual
10
83