Yamaha cvp-701 clavinova Reference Manual page 67

To get the most convenient use of this Talk function, use the [1] button to assign one of the pedals
(Left, Center, or AUX) to "TALK" in the following display: [DIRECT ACCESS] → press one of the
pedals (Left, Center, or AUX)
This allows you to use one of the pedals to switch the Talk function on and off during your performance,
without having to call up the menu above.
4
Use the [A] – [E] buttons to select the specific row (or group) of parameters to be
adjusted.
5
Set the value of specific parameters in the row by using the [1] – [6] buttons.
For information on each parameter, see
After setting, go to the Mic Setting Memory display by pressing the [H] (USER MEMORY) button and save the settings (see below
section). The settings will be lost if you exit from this display or turn the power to the instrument off without executing the Save
operation.
Saving the Microphone Settings
All the settings (VOCAL/TALK pages) are saved together as a single file. Up to ten files can be saved. For
ease in future recall, you should assign a sufficiently descriptive name to the file or one that matches your
performance.
1
On the MIC SETTING display (in step 3 above), press the [H] (USER MEMORY) button.
2
Press the [6] (SAVE) button to save the file to USER.
For details on the naming and deleting procedures, refer to the "Renaming a File/Folder" and "Deleting
Files/Folders" sections in the Owner's Manual.
The microphone setting file can be saved only to the internal USER drive. If you want to save this setting to the USB flash drive, save the User Effect file
on the display called up via [FUNCTION] → TAB [L][R] MENU2 → [G] SYSTEM → TAB [L][R] SETUP FILES → [H] (USER EFFECT FILES) →
TAB [L][R] USB → [6] (SAVE).
Calling Up the Microphone Settings Saved to USER
1
Call up the Mic Setting Memory display by pressing the [H] (USER MEMORY) button on the
MIC SETTING display.
2
Use the [A] – [J] buttons to select the desired setting file.
VOCAL Page
3-BAND EQ (selected by [A]/[B] buttons)
EQ (Equalizer) is a processor that divides the frequency spectrum into multiple bands which can be
boosted or cut as required to tailor the overall frequency response. This instrument features a high-grade
three-band (LOW, MID and HIGH) digital equalizer function for the microphone sound.
[1]/ Hz
[3]/
[5]
[2]/ dB
[4]/
[6]
page 67 – 68.
Adjusts the center frequency of the corresponding band.
Boosts or cuts the level of the corresponding band by up to 12 dB.
CVP-701 Reference Manual
7
67