Disabling Automatic Selection Of Voice Sets (Effects, Etc.) - Yamaha cvp-701 clavinova Reference Manual

2 DSP
[1] –
[4]
[6]
[5]/
[7]
2
3 EQ
Determines the Frequency and Gain of the Low and High EQ bands. For information about EQ, refer to
page 84.
 HARMONY Page
Harmony sets the Right 1 and 2 parts together. Before you set these parameters, make sure the Right 1 part
is selected in the Main display. This has the same settings as the display of "Selecting the Harmony/Echo
type" page 8

Disabling Automatic Selection of Voice Sets (Effects, etc.)

Each Voice is linked to its default VOICE SET parameter settings. Usually these settings are automatically
called up when a Voice is selected. However, you can also disable this feature by the operation in the relevant
display as explained below.
For example, if you want to change the Voice yet keep the same Harmony effect, set the KEYBOARD
HARMONY parameter to OFF (in the display explained below).
1
Call up the operation display.
[FUNCTION] → TAB [L][R] MENU1 → [F] VOICE SETTING → TAB [L][R] VOICE SET FILTER
2
Use the [A]/[B] buttons to select a keyboard part.
3
Use the [4] – [8] buttons to enable/disable automatic calling up of the settings
(ON or OFF) independently for each parameter group.
16
CVP-701 Reference Manual
DSP TYPE Selects the DSP effect category and type. Select the desired category
first, then a type.
VARI. A Variation parameter is provided for each DSP type. By turning this
on or off, you can instantly and significantly change the sound of the
DSP effect. Here, you can edit the VARI. (Variation) on/off status and
the parameter value for each status (in DETAIL below).
DETAIL Calls up the detailed setting display. Press the [5] button for edit-
ing the standard parameter value, and the [7] button for editing
the Variation parameter value.
In the detailed setting display, select the desired parameter by using
the [2] – [4] buttons then adjust the value by using the
[5] – [6] buttons. This differs depending on the effect type
and cannot be changed. Press the [EXIT] button to close the setting
display.
in step 3.
2
3