Midi Transmit Settings - Yamaha cvp-701 clavinova Reference Manual

 CHORD SYS/EX.
The "Tx" setting turns MIDI transmission of MIDI Chord System Exclusive data (chord detect, root and
type) on or off. The "Rx" setting turns MIDI reception and recognition of MIDI chord exclusive data
generated by external equipment on or off.

MIDI Transmit Settings

The explanations here apply to the TRANSMIT Page in step 4 on
be sent as MIDI data and over which MIDI channel the data will be sent.
1
1
1
Use the [A]/[B] buttons or [1]/[2] buttons to select the part for changing
transmit settings.
With the exception of the two parts below, the configuration of the parts is the same as those already
explained elsewhere in the Owner's Manual.
UPPER
A keyboard part played on the right side of the keyboard from the Split Point for the Voices (RIGHT 1
and/or 2).
LOWER
A keyboard part played on the left side of the keyboard from the Split Point for the Voices. This is not
affected by the on/off status of the [ACMP ON/OFF] button.
2
Use the [3] buttons to select a channel via which the selected part will be
transmitted.
If the same transmit channel is assigned to several different parts, the transmitted MIDI messages are merged to a single channel — resulting in unex-
pected sounds and possible glitches in the connected MIDI device.
Protected Songs cannot be transmitted even if the proper Song channels 1-16 are set to be transmitted.
3
Use the [4] – [8] button to determine the types of data to be sent.
The following MIDI messages can be set on the TRANSMIT/RECEIVE display.
NOTE (Note events)
CONTROL CHANGE
PROGRAM CHANGE
PITCH BEND ...................page 64
AFTER TOUCH................page 64
2 3
.........page 64
......page 64
.....page 64
page 94. This determines which parts will
The dots corresponding to each channel (1–16)
flash briefly whenever any data is transmitted on
the channel(s).
If "WLAN" is shown, this instrument can handle
MIDI messages received via the USB wireless
LAN adaptor connected to the [USB TO DEVICE]
terminal. When "WLAN" is not shown although
the USB wireless LAN adaptor is connected, turn
the instrument off then on again.
CVP-701 Reference Manual
11
97