Wan Setup For Pppoe (Dsl) - Motorola VT2142 User Manual

Overview

WAN Setup for PPPoE (DSL)

PPPoE Connection Setup fields and buttons
Field or Button Description
Options We recommend leaving the following selected:
• NAT — Enables
• Firewall — Enables the VT2142 firewall
Your PPPoE user name provided by your DSL provider.
User name
Your PPPoE password provided by your DSL provider.
Password
Sets the time before your DSL provider terminates an inactive connection. To ensure that your
Keep Alive
DSL link is always active, type 0 in this field.
Sets the authentication:
Authentication
• Auto — Automatic
• CHAP — Challenge Handshake Authentication Protocol
• PAP — Password Authentication Protocol
Microsoft CHAP v2 is supported in the Auto and CHAP options. MS CHAP v1 is not supported.
The maximum transmission unit for the DSL connection. It is a negotiated value that represents
MTU
the maximum size in bytes of the packets sent over the connection. The default is 1492. The
maximum is 1500. The minimum is 64.
If your cable or DSL provider associates a particular service to a specific device, such as your
Override MAC
computer, select this field and type that MAC address in the MAC field to use as a "virtual"
MAC address
VT2142 is displayed in this field.
Restores the actual VT2142 MAC address.
Restore
If enabled (the default), all
Enforce MTU
this, you may have problems accessing some Internet sites.
Enables PPPoE debugging for use by technical support personnel only.
Debug
VT2142 Voice Gateway User Guide
Installation Troubleshooting
Configuration:
Network Address Translation
instead of the VT2142 MAC address. By default, the MAC address printed on the
TCP segments must have a size within the PPPoE MTU. If you disable
Contact FAQ
Basic Advanced TCP/IP
Glossary License
WAN
16