Wan Setup For Pppoe (Dsl) - Motorola RSGu3500 User Manual

WAN Setup for PPPoE (DSL)

PPPoE Connection Setup fields and buttons
UNCONTROLLED DOCUMENT
Field or Button Description
Options
User name
Password
Authentication
MTU
Override MAC
Restore
Enforce MTU
Debug
Connect
Disconnect
RSGu3500 Residential Seamless Mobility Gateway User Guide
Overview Installation Troubleshooting Contact
Configuration: Basic
We recommend leaving the following selected:
• NAT — Enables Network Address Translation
• Firewall — Enables the RSGu3500 firewall
Your PPPoE user name provided by your DSL provider.
Your PPPoE password provided by your DSL provider.
Sets the authentication:
• Auto — Automatic
• CHAP — Challenge Handshake Authentication Protocol
• PAP — Password Authentication Protocol
Microsoft CHAP v2 is supported in the Auto and CHAP options. MS CHAP v1 is not supported.
The maximum transmission unit for the DSL connection. It is a negotiated value that represents
the maximum size in bytes of the packets sent over the connection. The default is 1492. The
maximum is 1500. The minimum is 64.
If your cable or DSL provider associates a particular service to a specific device, such as your
computer, select this field and type that MAC address in the MAC field to use as a "virtual"
MAC address instead of the RSGu3500 MAC address. By default, the MAC address printed on
the RSGu3500 is displayed in this field.
Restores the actual RSGu3500 MAC address.
If enabled (the default), all
this, you may have problems accessing some Internet sites.
Enables PPPoE debugging for use by technical support personnel only.
Establishes the DSL connection.
Ends the DSL connection. If you disconnect your DSL connection, your VoIP service cannot work.
Advanced
TCP segments must have a size within the PPPoE MTU. If you disable
FAQ Specifications Glossary License
TCP/IP Wireless
WAN
14