Electrical Requirements; Treadmill Assembly - True ZTX 825HRC Owner's Manual

Section A
Setting Up Your Treadmill

Electrical Requirements

Your TRUE treadmill requires either: a) Dedicated
120 VAC (108-132 VAC, 50/60 Hz), 20 amp,
grounded outlet circuit (The receptacle must be a
NEMA 5-20R Receptacle), or b) Dedicated 230
VAC (207 -253 VAC, 50/60 HZ), 20 amp, grounded
outlet circuit (The receptacle must be a NEMA 6-20
R. Receptacle). This grounded outlet is especially
critical for the HRC system (ZTX 825 HRC to
function properly.
CAUTION:
Make sure that the product is connected to an outlet
having the same configuration as the plug. No adapter
should be used with this product. Do not defeat the
grounding function by:
a. Removing the "third" ground pin from the plug, or
b. Using an extension cord.
La Prudence:
S'assurer que le produit est connecté à une sortie configura-
tion pareile qui a comme le bouchon. Aucun adaptateur
devrait être utilisé avec ce produit. Ne pas battre la fonction
qui mettre à terre par:
NOTE:
This unit has a either a) A NEMA 5-20 plug and requires a
NEMA 5-20 receptacle, or b) A NEMA 6-20 plug and
requires a NEMA 6-20 receptacle.
NOTE:
Units produced for use outside of the U.S.A. will have
voltage listed on the identification tag.

Treadmill Assembly

To assemble your True ZTX treadmill it is necessary to lift the pedestal into position and
assemble the handrails.
NOTE:
When assembling the treadmill, it is not necessary to re-
move the motor cover. All electrical connections have been
made at the factory
8
a. Enlever la "troisième" épingle de sol du bouchon, ou
b. L'utilisation d'une rallonge.
Figure A Figure B
Continued on Next Page