Calibration
Incline and Speed Calibration
4. Remove and replace Safety Key to exit Calibration Mode
Error And Service Codes
The following Error Codes and Service Codes will follow a double "beep" and show on
the display. Service Codes provide preventive maintenance reminders. A Service Code will
repeat for the next five times you start the treadmill. A Service Code will clear after any
key has been pressed. When an Error Code occurs, call an authorized service technician.
The Error Codes display differently on the ZTX 825P/HRC than on the ZTX 825.
Error/Service Code Description
ZTX 825P/HRC ZTX 825
E1: MINIMUM
E1: RANGE
E1: STALL
E1: INCLINE
E2: OVERSPEED
E2: CAL
E2: RECAL
E3: EEPROM
E5: SENSOR
S1: LUBE
S2: CLEAN
E1 _
Not Used
E1 r
This error occurs when the incline values on the display do
not match the values stored during calibration.
This error occurs when the incline motor does not move in
E1 S
response to an incline command.
E1 i
This error occurs when the incline motor moved without an
incline command.
E2 O
This error occurs when acceleration exceeded design limits.
E2 C
This error occurs when the speed displayed does not match
the stored value from calibration.
E2 r
This error occurs when a data error is detected at start up.
The Control Panel has reset to default values.
This error occurs when a data error is detected on the
E3 E
EEPROM. Replace Control Panel circuit board.
E5 S
This error occurs when no speed sensor data has been
detected at the Control Panel.
S1 L
This code occurs every 3460 miles to remind you to inspect
the autowaxer.
This code occurs every 500 miles to remind you to clean the
S2 C
treadmill.
Section E
(Continued)
Description
99