Diagnostics - True ZTX 825HRC Owner's Manual

Section E

Diagnostics

Your True ZTX treadmill is equipped with built in diagnostic capabilities to assist in
configuring, maintaining and servicing your treadmill. The Field Diagnostic mode provides
total hours, distance, average speed, ability to change the units of measure, ability to set
the "user not present" function, a list of service and error codes, the ability to set program
time, and a log of the last five errors.
NOTE:
Messages appear in the Message Center on the ZTX
825P and the ZTX 825HRC. The messages display
differently on the ZTX 825 and appear in the Primary
Display Window. They are shown below in parentheses.
1. Hold the
The following messages will repeat themselves:
DIAGNOSTIC
PRESS START
2. Press to display total hours.
The following messages will display:
HOURS
3. Press to display total distance.
The following messages will display:
DISTANCE
4. Press to display average speed.
The following messages will display:
AVG SPEED
5. Press to display units. Press
The following messages will display:
UNITS
6. Press to display User Not Present function.
The following messages will display:
CURRENT SHUT
7. Press repeatedly to display list of errors.
The service/error codes will be listed. See Error and Service Codes on the
previous page.
100
while placing the Safety Key on the Keyboard.
(diAg)
(ttL)
(dIS)
(ASP)
ENG (Eng) or MET (H)
(Crnt)
No. of hours on the treadmill
No. of miles on the treadmill
Average speed on the treadmill
or to toggle.
No. of seconds until treadmill
shuts off with no user on tread belt