Blackmagicdesign Blackmagic URSA Installation And Operation Manual page 74

Upgrading the Sensor Turret on the URSA model
75
Replacing the Sensor Turret
Step 1.
Apply new thermal gap pads, supplied with your
new URSA turret assembly, to both cleaned copper
blocks in the camera chassis. Ensure the fold out
monitor cable is seated against the inside wall.
A
D
Step 4.
Using the torque wrench, apply one full turn of
pressure to mounting screw A, followed by one
full turn to screw B, and repeat for screws C and D.
Continue to apply one full turn to each screw in the
described sequence until all screws have reached
the maximum allowable torque of 3 Nm.
Step 2.
Align the sensor turret so the alignment pins slot
into the three alignment holes and gently press
downward until you feel the sensor data connector
join with the mating chassis connector.
C
B
Step 5.
Reattach the 15mm rails mount by placing the front
of the mount against the camera base and rotating
it into place. Using the torque wrench, gradually
and evenly tighten the screws until all have reached
the maximum allowable torque of 3 Nm.
Step 3.
Loosely fasten the four sensor turret mounting
screws and spring washers until initial contact is
made between the sensor turret and the camera
body. It's important you do not tighten the screws
at this point.
Step 6.
Reattach the quick release V-Mount plate by
tightening the screws using a flat head screw
driver, and reattach the third party battery plate
(if any) to Blackmagic URSA's rear panel.
Congratulations, you have now upgraded your
Blackmagic URSA!