Blackmagicdesign Blackmagic URSA Installation And Operation Manual page 70

URSA Mini Shoulder Kit Assembly
71
To attach the top handle with URSA Viewfinder:
Top handle
Step 1.
Place your URSA Mini on a flat, stable surface so
you can access the top of your camera.
2 x 1/4" socket head screws for Thumbscrew for adjusting the
mounting handle to camera optional URSA Viewfinder position.
URSA Viewfinder cap
Step 2.
Remove the URSA Viewfinder cap from the
base of the handle by gently lifting its arm away
from the side of the handle and pulling the cap
from the hole.
Step 4.
Fasten the handle to any two of URSA Mini's top 1/4" mounting points using the two supplied 1/4" screws
with a 5mm hex key driver. URSA Mini's rear two mounting points are recommended for most situations,
but you can choose any pair for better weight balance when using large lenses. Avoid over-tightening
the screws as it may damage the screw threads.
The hole inside the front of the handle is used with the thumb screw when attaching and adjusting the
URSA viewfinder. For information on how to attach the URSA Viewfinder to the top handle, refer to the
'Blackmagic URSA Viewfinder' section in your URSA manual.
URSA Viewfinder adapter plate
Step 3.
Fasten the URSA Viewfinder adapter plate to the
handle using the 4 x M3 screws with a 2.5mm hex
key driver.