Table of Contents
Advertisement
STEP 10 ADJUST DOOR SWING
NOTE: This refrigerator has a 3-position door stop.
When space does not allow the door to swing open
fully to 115°, you may change the door swing to a 90°
opening. A 130° door swing is available for standard
installation only. If used for flush installation, damage
will occur to wood panels. Skip this step if door
opening is satisfactory for your installation situation.
• Lift the grille panel to access the wire cover trim.
• Remove screws on both sides of the wire cover trim
and rotate off.
• Use pliers to unscrew door stop and reinstall into the
90° or 130° (standard only) position.
Remove
Wire Cover
Trim Screws
Pin Location
for 90°
Door Swing
• Reinstall the wire cover trim.
STEP 11 REMOVE DOOR TRIM - FLUSH
INSTALLATION ONLY
Use the supplied Torx wrench or T10 Torx head driver to
remove all exposed trim screws securing aluminum trim to
refrigerator doors. Save all trim and screws as they will be
replaced in a later step.
1. Remove 4 screws and trim from the hinge side of the door.
2. Remove 4 trim screws on vertical handle side of the door to
release handle cover trim. Remove the handle cover trim to
expose handle visor trim underneath.
3 Remove 4 additional trim screws from handle visor trim.
Once screws have been removed, remove handle visor
trim.
4. Remove 2 screws and trim from each side of the drawer.
These screws are longer than the other trim screws. Make
sure these are used when reinstalling side trim to drawer.
Installation Instructions
Pin Location for
130° Door Swing
(Standard Only)
Pin Location
as Shipped
for 115°
Door Swing
19
STEP 12 REMOVE DOOR TRIM - FLUSH
INSTALLATION ONLY (Cont)
5. Remove 1 screw and side brackets from each side of the
drawer.
6. Remove screws and drawer cover from top of the drawer.
7. Remove screws and visor from top of the drawer.
Handle
Cover Trim
Handle
Visor Trim
Top
Drawer
Visor
Drawer Side
Brackets
Drawer
Side Trim
Hinge Side
Door Trim
Top Drawer
Cover
Advertisement
Table of Contents
