Position Of Pocket Plate Arm - Pfaff 3568-12/22 Instruction Manual

Adjustment
13

Position of pocket plate arm

.08.12
13 - 53
Requirement
1. When the pocket plate 3 is lowered, it must be parallel to the table.
2. The lengthwise motion of the pocket plate 3 must run parallel to the table.
Fig. 13 - 51
Loosen screws 1 and 2 just enough so that the bearing housing of the pocket plate arm
can only be moved with difficulty.
Align pocket plate arm by moving the bearing housing according to requirement 1.
Turn off compressed air.
Remove pocket plate 3 and measure the distance to the edge of the table.
Move pocket plate 3 back a little and measure the distance to the edge of the table again.
If both distances are not equal, align the pocket plate arm according to requirement 2.
Check requirement 1 and realign pocket plate arm if required.
Tighten screws 1 and 2; turn on compressed air.
3
1
=
=
2