Basic Position Of The Work Clamp ( Lengthwise To The Arm ) - Pfaff 3119 Instruction Manual

13 Basic position of the work clamp
.15
Requirement
When the clamp 1 is in its basic position, there should be a distance of 5 mm, or 9 mm on
machines with sub-class -2/62 and -2/63, from the centre of the needle hole to the work clamp.
Fig. 13 - 11
Connect the compressed air system and switch on the machine.
Lower the work clamp 1 ( control panel ).
Adjust bar 2 ( screw 3 ) according to the requirement.
Switch off the machine and disconnect the compressed air.
( lengthwise to the arm )
1
Adjustment
3
2
1
56-048a
13 - 14