13
Adjusting the folding and feed devices
.08
13
Adjusting the switch vanes on the X/Y control
.08.01
Requirement
The overlap of the switch vanes 1 and 3 to the carrier
1. is to be 18 mm on the carriage for the Y direction.
2. is to be 15 mm on the carriage for the X direction.
Fig. 13 - 40
Move switch vane 1 (screws 2) according to requirement 1.
Move switch vane 3 (screws 4) according to requirement 2.
Set zero point (see chapter 9.02.02 Adjusting zero point).
2
1
Adjusting the switch vanes 1 and 3 is only necessary when the carriage guides
have been replaced or when the zero point setting causes problems.
2
4
Adjustment
4
3
13 - 42