Pfaff 3568-12/22 Instruction Manual page 56

Programing
5- TIMES
Under this main function, times are listed which can be set via the plus/minus keys or the
number keys.
. . .
6- SERVICE
The service functions are only intended for the mechanics. A detailed description is found in
the service manual for the machine control.
11 - 12
1- TIME FOR STACKER AIRBLAST
The time is to be set so that the stacker goods are blown properly over the stacker
trestle.
2- TIME FOR FOLDER DOWN
The time is to be set so that the function "folder down" already begins during the
function "folder forward", but is just ended in the forward end position of the folder.
3- TIME FOR PULLER DOWN
The time is to be set so that the puller is lowered only after the sewing jig has moved out
of the puller area.
4- TIME AFTER TABLE UP
The time is to be set so that the folder plates don't move back until the table is at the top.
5- TIME FOR EDGE FOLDERS
The time is to be set so that the folder moves to the top after the folder plate is at the
back end position.
6- TIME FOR FEED FORWARD
The time is to be set so that the sewing jig feed from the folder station to the sewing
station is carried out after the pocket plate has moved out of the jig area.
7- TIME FOR THREAD PULLER
The time is to be set so that the thread puller cylinder can carry out the complete stroke.
1- SEWING MOTOR FUNCTIONS
1- SEWING MOTOR TURNING
2- TRIMMER SPEED SELECTION
3- THREAD TRIMMING SEQUENCE
2- STEPPING MOTORS
1- STEPPING MOTOR X-AXIS
2- STEPPING MOTOR Y-AXIS
3- DISPLAY INPUTS
4- SET / RESET OUTPUTS
5- SET ZERO POINT
6- SOFTWARE DATE
7- COLD START