Feed Changeover - Pfaff 3568-12/22 Instruction Manual

13

Feed changeover

.08.03
Requirement
1. The jig frame must just touch the sewing changeover and be both parallel and
horizontal.
2. On the folding station, the sewing jig must be positioned parallel to the pocket plate
and/or to the table.
3. When the jig changes over, the jig frame must not move.
2
6
Fig. 13 - 42
Move eccentric pin 1 (nut 2) according ot the requirements 1 and 2.
Repeat this work step until both adjustments are correct.
Align jig frames (screws 3 and 4) horizontally.
Adjust carrier 5 (screws 6) according to requirement 3, making sure that the home
position of the transport arm does not change (see chapter 13.08.02 Home position of
the transport arm).
5
1
4
3
6
6
Adjustment
4
3
13 - 44