St - Status Display - AT&T DEFINITY Remote Port Security Device User Manual

ST - Status Display

Syntax:
[ ]
st
RETURN
The Status Display command displays the version, date, time, communications parameters, and
current status of the RPSD Lock.
Sample Command and Response:
> st
AT&T RPSD/JPLock01 - V1.1a Firmware V2.Ot
Current Date: Mon 11/12/90 Time: 16:11:55
Comms. Set to: 9600/8N
Current Status: Idle/Locked
The fields of the Status Display screen are:
AT&T
Gives the version number of the equipment.
RPSD/JPLock01
Firmware
Gives the version number of the firmware.
Init Code Tells where and when the device was initialized.
Current Date Gives the current date. If the date is wrong, it can be corrected using the
Date Set command described in this section.
T i m e Gives the current time. If the time is wrong, it can be corrected using the
Time Set command described in this section.
Log ID Provides the Log ID of the RPSD Lock. To set a Log ID, use the
Set Log ID command described in this section.
Comms Set to Displays the setting of the communications parameters. To change the
communications parameters, use the Set Communications Parameters
command described in this section. The default setting is 9600 baud at
8 bits, no parity.
Provides the current status of the Lock.
Current Status
3-22
RPSD System Administration
Init. Code: DR
Log ID: