N - Set Device Number; L - List User Information - AT&T DEFINITY Remote Port Security Device User Manual

N - Set Device Number

Syntax:
n <number>
[
RETURN
The Set Device Number command enters a number from 100 to 9999999 as an identifier for the
RPSD Key device. Use this command when you have two or more RPSD Keys with the same
user ID. The device number is associated with the Key for the purpose of identification by the
RPSD Lock. This command is only used when initializing a Key in the virgin state. See Chapter
2, Initializing an RPSD Key for a complete description of the procedure which uses this
command.
Enter n <device_number> [
an arbitrary number between 100 and 9999999 that you select to be used as an identifier for that
particular RPSD Key device. Be certain not to duplicate existing device numbers. The last four
digits of the RPSD Key AT&T serial number is recommended.
Sample Command and Response:
> n 12345
08/14/90 14:03:59 Device Number set to 12345

L - List User Information

Syntax:
[ ]
l
RETURN
The List User Information command will list the user ID, device number, and test response
number for the Key.
To use the List User Information command, enter l [
Key user's terminal.
Sample Command and Response:
>l
User ID: KEY20
Device Number: 12345
Test Response: 8119704
]
], where n is the command and <device_number> is
RETURN
] at the
prompt of the
RETURN >
RPSD Key User Command Set 4-5