Front Sway Bar; Rear Sway Bar - Arctic Cat Wildcar Trail Service Manual

11. Using new "patch-lock" cap screws, install the brake
caliper and tighten to 20 ft-lb.
12. Install the wheel and tighten the lug nuts to 40 ft-lb
(steel wheels) or 80 ft-lb (aluminum wheels).
13. Remove the vehicle from the stand.

Front Sway Bar

REMOVING
1. Remove the front wheels (see Wheels and Tires in this
section).
2. Remove and discard the cap screws and lock nuts
securing the sway bar to the A-arm links.
3. Remove the sway bar bushing retainers and bushings
and slide the sway bar out of the vehicle.
INSPECTING
1. Inspect the sway bar for any signs of twisting or
cracking.
2. Inspect the bushing retainers and bushings for any
signs of wear or damage.
INSTALLING
1. Using new "patch-lock" cap screws and new lock
nuts, install the sway bar into position and secure it to
the lower A-arm links.
2. Install the bushing retainers and bushings. Finger-
tighten the cap screws only at this point.
164
2. Tighten the A-arm links to 20 ft-lb; then tighten the
sway bar link to 35 ft-lb.

Rear Sway Bar

REMOVING
1. Remove and discard the cap screws and lock nuts
securing the sway bar link to the lower A-arms on
both sides.
2. Remove the cap screws securing the sway bar to the
frame and remove the sway bar. Account for the bush-
ing retainers and bushings.
WT323A
INSPECTING
1. Inspect the sway bar for any signs of twisting or
cracking.
2. Inspect the bushing retainers and bushings for any
signs of wear or damage.
INSTALLING
1. Using new "patch-lock" cap screws and new lock
nuts, secure the sway bar to the lower A-arm link. Fin-
ger-tighten only at this point.
2. Install the bushings and bushing retainers. Finger-
tighten only at this point.
3. Tighten the lower A-arm links to 20 ft-lb; then tighten
the sway bar link to 35 ft-lb.
WT324
WT320A
WT315B