Operation - Yunca Gas EROS User Manual

OPERATION

How To Light Your YUNCA EROS
Refer to Fig 5.
Fig 5: Control Panel.
7. First read all the instructions for the heater.
2. Check that the control knob "A"(Fig 5) is in the off position, the thermostat knob "B" is turned
to its Highest setting (7) and back burner control "C" should be in the off position.
3. Turn off electric power at the wall.
4. Turn the knob "A" slightly anti-clockwise to stop. Push the control knob "A" fully down and
turn left from OFF to IGN, hold for 5-15 seconds. Continuing to hold down, turn the knob "A"
further anti-clockwise to pilot mark. Observe pilot light by looking through front door. The pilot
light is visible under the left hand end of the log set.
5. When the pilot is lit, continue pushing in knob for further 20 seconds to allow safety
thermocouple to heat up. Release knob and pilot flame should remain lit. If it goes out repeat
steps 4 and 5
6. The pilot control knob "A" can now be turned fully left to the ON position to light the front
burner.
7. Turn on electric power and the fan.
8. After the front burner has been on for at about 3 minutes. Turn the back burner on, by
pushing in knob "C" and turning Anti-Clockwise to maximum position.
25-07-01 Page 10 of 23 Operation Instructions for Eros Free Standing Gas Fire July 2001.doc