Manual Control Operation; Battery Replacement - Yunca Gas entis Installation & Operation Manual

MANUAL CONTROL PANEL OPERATION
Should the remote control be mislaid or damaged, your fire
can be operated using the control box panel on the front
of the fire (pictured right) accessible from the right hand
side of the bottom air vent.
Press and hold the POWER button to light the fire (starts on
high).
Press again to reduce to medium, and again to reduce to
low.
A further press of the power button will turn the fire off.
The PWR light will flash if battery is low.
The AUTO light will flash (when the fire is off) as a reminder that the timer has been activated.
BATTERY BACK UP - REPLACEMENT
Your YUNCA entis will operate for up to 200 hours (WITHOUT FAN BOOST) if power is not
available. Two "D" size batteries are located behind the fascia on the bottom left side, next to
the fan box.
To remove the batteries, remove the fascia (see page 5) and press down on the top of the
battery cover, this will allow the flap to open and the batteries to become exposed for
replacement. The cover shows the polarity of the batteries.
Always ensure the batteries are fresh, and consider changing these once a year (end of
summer daylight saving time, when you change your smoke alarm batteries, is a good routine.
You will have fresh batteries for the coming winter).
Revised 22-08-07
Yunca entis instal Aug07
IR receiver
Auto setting on Power on &
(indicator) Battery low
(indicator)
Control box
panel
(see above)
Fan box and
switch
Page 12 of 23
Power