Installation - Yunca Gas EROS User Manual

INSTALLATION

Considerations
The most desirable and beneficial location for a YUNCA EROS HEATER is in the centre of a
building, thereby allowing the most efficient use of the heat created.
The location of windows, doors and the traffic flow in the room where the heater is to be located,
should all be considered.
If possible a location should be selected that allows the flue pipe to be installed simply and pass
through the house without cutting a floor or roof joist.
To obtain maximum heat distribution with any freestanding heater a ceiling fan can be fitted.
Another important consideration when installing the Yunca EROS is availability of power supply
to the fan.
When the appropriate position has been selected the unit can be bolted to the floor to ensure that
the unit remains upright in the event of an earthquake or similar. A template has been supplied
with your heater and should be placed on the floor so holes can simply be drilled through the
template. The flue centre is also marked so a plumbob can be used to find the centre of the
ceiling flue.
If the heater is being attached to a concrete floor dyna bolts should be used, if the floor is
wooden the bolts used should be long enough to go fully through the floorboards and fixed with
nuts and washers from the underside.
The earthquake brackets are located at the rear corners of the heater and are exposed by
removing the cover.
25-07-01 Page 4 of 23 Operation Instructions for Eros Free Standing Gas Fire July 2001.doc