Yunca Gas EROS User Manual page 13

REPLACING THE GASKET.
The YUNCA EROS has a 10mm fibreglass gasket surrounding the front door. Should it ever
need replacement, use only the replacement gasket that is available from your YUNCA dealer.
The reference number for this is listed in the parts list.
Procedure.
1. Remove the front door as described on previous page.
2. Remove the existing gasket and clean the channel of all loose material.
3. Lay the gasket in the channel, starting from one end.
4. Replace the door carefully to avoid dislodging the gasket.
Cleaning The Glass
The glass may be cleaned with ordinary household glass cleaner and a soft cloth or paper towel.
Note: Never clean the glass when it is hot. Do not use abrasive cleaners on the glass.
CLEANING THE LOG SET AND FIREBOX.
During the annual inspection and maintenance appointment, the service person should clean dust,
lint and any light soot accumulation from the logs and the fire box area. An extra soft brush
should be used on the logs as they are extremely fragile. If at any time the logset cannot be
removed or installed without force, the cause must be found. The logset must never be forced.
Procedure.
1. Remove front door as described previously.
2. Remove the inner hearth by removing the screws along the lower front and lifting clear.
3. Remove the loose side coals with care. Gently brush clean.
4. Remove the log set from the firebox by lifting it up and out.
5. Brush it gently over a newspaper and carefully place it out of the way.
6. Vacuum cleaner can be used to remove any visible dust and lint from within the firebox
area.
7. In and around the pilot light assembly the fine gas ways need to be clean and free from
obstruction. The jets may require to be checked for obstructions
8. Replace the logset and then the loose coals.
9. Replace the inner hearth.
25-07-01 Page 13 of 23 Operation Instructions for Eros Free Standing Gas Fire July 2001.doc