Operation - Yunca Gas LEEDZ Operations, Maintenance & Warranty Information

OPERATION

How To Light Your YUNCA LEEDZ
Refer to Fig 5.
1. First read all the instructions for the heater.
2. Check that the control knob "A"(Fig 5) is in the off position, the thermostat knob "B" is
turned to its Highest setting (7) and back burner control "C" should be in the off
position.
3. Turn off electric power at the wall.
4. Turn the knob "A" slightly anti-clockwise to stop. Push the control knob "A" fully down
and turn left from OFF to IGN, hold for 5-15 seconds. Continuing to hold down, turn
the knob "A" further anti-clockwise to pilot mark. Observe pilot light by looking
through front door. The pilot light is visible under the left-hand end of the log set.
5. When the pilot is lit, continue pushing in knob for further 20 seconds to allow safety
thermocouple to heat up. Release knob and pilot flame should remain lit. If it goes out
repeat steps 4 and 5
6. The pilot control knob "A" can now be turned fully left to the ON position to light the
front burner.
7. Turn electric power on and the fan to low speed.
8. After the front burner has been on for at about 3 minutes. Turn the back burner on,
by pushing in knob "C" and turning Anti-Clockwise to maximum position.
25-07-01
Fig 5: Control Panel.
Page 9 of 22 Operation Instructions for Leedz Free Standing July 2001.doc