Operation - Yunca Gas LEEDZ INBUILT Operations, Maintenance & Warranty Information

OPERATION

How To Light Your YUNCA LEEDZ
1. First read all the instructions for the heater.
2. Check that the control knob "A"(Fig 5) is in the off position, the thermostat knob "B" is turned to its
Highest setting (7) and back burner control "C" should be in the off position.
3. Turn off electric power at the wall.
4. Turn on the pilot light. Turn the knob "A" slightly anti-clockwise to stop. Push the control knob "A"
fully down and turn Anti-Clockwise from OFF to ING, hold for 5-15 seconds. Continuing to hold
down, turn the knob "A" further anti-clockwise to pilot mark. Observe pilot light by looking through
front door. The pilot is located under the left-hand end of the front log set and is visible through the
gap between the front two logs.
5. When the pilot is lit, continue pushing in knob for 20 seconds to allow safety thermocouple to heat
up. Release knob and check pilot flame has remained lit.
6. Turn on front burner only. The control knob "A" can now be turned fully to the ON position to light
the front burner
7. Turn electric fan power on and set to low speed.
8. After the front burner has been on for at about 3 minutes. Turn the back burner on, by pushing in
knob "C" and turning Anti-Clockwise to maximum position.
9. Allow both burners to run for 30 minutes to bring the room up to temperature.
09-06-01
If it goes out repeat steps 4 & 5.
Page 9 of 9 op-instruct-leedz-ib.doc