Yunca Gas EROS User Manual page 7

CONNECTING THE HEATER TO A GAS SUPPLY
.
Burn only the fuel for which the heater is equipped.
The YUNCA EROS may be shipped from the factory equipped to burn natural gas, Propane or
L.P.G. The data plate affixed to the back of the heater specifies the gas type which the heater is
factory equipped for. Fuel Conversion Kits are available from your YUNCA agents.
See Appendix: A for instructions on field conversion from one gas to another. This conversion
can only be done by a suitably qualified person.
Gas connection:
The gas inlet is located behind the fan Back Pane. The inlet thread is a female 3/8" BSP.
A separate gas isolation valve should be installed immediately up stream of the connection to the
appliance.
WARNING: To stop pipe compounds entering the gas line, do not apply sealing compounds to
the first two threads at the tip of any gas connection. All joints should be tested for leaks before
operating the heater.
25-07-01 Page 7 of 23 Operation Instructions for Eros Free Standing Gas Fire July 2001.doc