Yunca Gas EROS User Manual page 11

9. Allow both burners to run for 30 minutes to bring the room up to temperature.
10. Turn the back burner off.
11. Adjust the thermostat down, to the front burner turns off. Note the thermostat number and
turn up by ½ to1 ½ a thermostat number till the front burner turns on.
12. Leave the fan on. Note Fan can be turned off, Higher efficiency is achieved with the fan
running
To further increase the room temperature follows the following steps:
st
1 Turn the thermostat up one number.
nd
2 Turn the secondary burner on to minimum.
rd
3 Turn the secondary burner up to maximum.
Note: Various combinations of the settings of knobs "B" and "C" will provide different heat
settings and flame effects.
The first few times that the heater is lit it should only be running for about twenty minutes.
And then allowed to cool. This will eliminate damage to paints and reduce the smoke and
odour caused by burning off of manufacturing oils etc.
HOW TO TURN OFF THE HEATER.
1. Turn the rear burner control, knob "C", to the off position.
2. Turn off the electrical power at the wall.
3. Push in the pilot control knob "A" and turn it clockwise to off.
Note: The knob cannot be turned from "pilot" to "off" unless it is pushed in slightly.
Do not force it.
25-07-01 Page 11 of 23 Operation Instructions for Eros Free Standing Gas Fire July 2001.doc